How do you retrieve the MAC Address of the BC600 without UART connection?

FIX - BACK TO COMMAND MODE iOS DOES NOT SHOW MAC ADDRESS IN ADVERT DISPLAY - ONLY DEVICE NAME. Q. I set up the BC600 jumper based on page 20 of the User Guide as VSP Bridge to UART mode jump "pin 5 and 6" and "pin 2 and 3". I have problem getting MAC address from BC600 though using the user guide link since my unit do not have connector Is there other way I find MAC? A. The MAC address of the BC600 can be retrieved using the Laird Toolkit  Application for Android/iOS devices while the device is in vSP Bridge to UART mode. Install the Laird Toolkit   v4.18.1.13 on an Android or iOS device. (Note there are several older versions of Laird Applications, the one you will want is just " Laird Toolkit ") Open the Laird Toolkit application and select Serial (VSP). Place the BC600 in VSP Bridge to UART Mode: Jumper on pins 2 & 3 Jumper on pins 5 & 6 Power cycle the module to boot into vSP Bridge to UART mode .  The device will begin advertising for a connection (this will time out in 10 seconds). Press [ Scan ] in the Laird Toolkit application. You should see  LAIRD BL600   in the list of vSP devices : the MAC Address is listed under the Device Name.