How do I setup the ST60 for hostapd?

Configuring the ST60 for hostapd to take advantage of it's max data rate requires a bit of setup. For hostapd to take advantage it has to know all the capabilities of the radio which can be pull from 'iw list'. One will need to convert the capabilities from 'iw list' to ht_capab and vht_capab. To help do this conversion reference the hostapd full config documentation.

Note: hostapd is not officially supported at this time, but wpa_supplicant setup as an AP is support via the sterling-supplicant which can be obtained here: Sterling-60.

Below is a sample working configuration for the ST60.


# hostapd configuration
ctrl_interface=/var/run/hostapd
ctrl_interface_group=0
interface=wlan0
driver=nl80211

# IEEE 802.11
ssid=hostAPD

hw_mode=a
channel=149
max_num_sta=12
auth_algs=1

# DFS
country_code=US
ieee80211d=1
ieee80211h=1

# IEEE 802.11n
ieee80211n=1
ht_capab=[HT40+][LDPC][SHORT-GI-20][SHORT-GI-40][RX-STBC1][DSSS_CCK-40][MAC-AMSDU-3839]

# IEEE 802.11ac
ieee80211ac=1
vht_oper_chwidth=1
vht_capab=[MAX-MPDU-3895][RXLDPC][SHORT-GI-80][RX-STBC-1][TX-ANTENNA-PATTERN][RX-ANTENNA-PATTERN]
vht_oper_centr_freq_seg0_idx=155

# IEEE 802.11i
wpa=2
wpa_key_mgmt=WPA-PSK
wpa_passphrase=password1
rsn_pairwise=CCMP

 

Categories

Products

Parts